Better And Safer To Use

- Jun 13, 2018-

As a professional manufacturer of vulcanizing machine equipment, in order to avoid the machine in the process of using, the operator has an unexpected situation, in particular to remind customers that several vulcanizing machines are prone to dangerous places:

Crushing and/or shearing hazards: movement of the protective guard; whipping of a high pressure hose above 5 MPa; instability or dumping of the vulcanizing press.

The hydraulic system is in danger of failure and controls the electrical components of the system.

Liquid Hazard Under Pressure: Unexpected release of liquid fluids from hydraulic, pneumatic, or heated temperature control systems, especially high pressure hoses and fittings above 5 MPa, can cause eye and skin damage. Electrical Hazard: A call or electrical burn caused by direct or indirect contact with live parts. Heat Hazard: The operating temperature of the heating system hoses and accessories may cause burns and burns.

Noise Hazard: High-grade noise, such as hearing loss, deafness, hearing fatigue, nervousness, impairment of perceptual balance, interference or noise in speech conversation, signal cover by noise, etc. Danger of dust, gas, and smoke.

The following occasions may touch or inhale the dangers of harmful dust, gas, and fumes from human health: when moulding materials are built into moulds; when the products are cured or vulcanized in moulds, the moulds are opened. Slip, trip and fall hazards. The risk of slipping, tripping, and falling on a high work station on a flatbed vulcanizer or in and out of a flatbed vulcanizer.

If the vulcanizing machine leaks, first of all check whether the vulcanizer production raw material contains a lot of water, if not, you should see whether the car is rubber mouth perfect, and then try the rotor, the mixing room, the unloading door, the hammer, and check the leaking position.

The vulcanizing machine is very difficult to leak water. The main reason for this is the reason of carbon black, because carbon black will absorb the moisture in the air. Mixing temperature will produce a large amount of water vapor at about 100 degrees, and the vulcanizing machine will accumulate The water will mistakenly believe that the mixer leaks water. The way to eliminate water vapor is to lift the pressure lid several times in the mixing process to drain the water, so that there will be no water.